To run Synopi Natiply ISO, you will require some equipments (hardware or software). Here is the list of prerequisites for installing Natiply ISO:

1) A PC/Server on which Synopi Natiply ISO will be installed
2) A USB Flash Drive
3) Multiple Internet Connections
4) A Server in your local Data Center

This server will be used as the Synopi Natiply Server. Synopi Natiply has very low CPU usage and can be run on almost any computer. For maintaining the minimum stable standard, you may consider the following configuration:

• Motherboard: 64-bit architecture needed with USB bootable option. For Synopi Natiply, we prefer as many USB ports as possible on the motherboard. So that higher number of USB Modems (WiMAX, 3G/4G etc.) can be plugged directly.
• Processor: Intel Core i3/i5 or higher (64-bit needed).
• RAM: Minimum 4GB RAM is recommended.
• NIC (LAN Interface): A good and well tested branded 100/100 NIC/LAN Card is minimum preference.
• Hard Disk: 20 GB of Hard Disk space is required. You can use any type of Hard Disk, i.e. SATA/SCSI/SSD etc.
• Operating System: To run Synopi Natiply, we do not require any operating system.
• Monitor: Monitor is required for installation, troubleshooting and other support purposes.
• Network Switch: A good quality network switch is required to distribute internet connections among multiple users.
• LAN Cables: Like LAN Card and Network Switch, LAN Cables are also very important. Wrongly crimped cable causes faulty networking and results bad and low performance. A cat 6 cable with RJ45 connector is fine for LAN cables.
• USB Drive: A USB flash drive is needed with a minimum 4 GB of data capacity.
• Internet Connections: Synopi Natiply can bond any type of internet connection i.e. 2G, 3G, 4G/LTE, WiMax, Wi-Fi, ADSL, DSL, VSAT etc. It can support as many connections as the system supports.

 

If we have all the prerequisites handy as mentioned above, we are ready to go to the next step, burning Natiply ISO on USB flash drive.